SMR Gearbox Set up
Satisfactory functionality will depend on right set up. lubrication and upkeep. thus it is important the directions during the set up and servicing leaflet. provided with each gearbox. are followed meticulously. a few of the essential facets of belt and torque-arm set up are listed below.
one. Install pulley on gearbox input shaft as shut to your reducer possible, and mount reducer on driven shaft as shut to bearing as useful. failure to perform this can cause excess loads inside the input shaft bearings and output bearings and could cause their premature failure.
2. Install motor and wedge belt drive with the belt pull at around 90° to your center line between driven and input shafts. this will likely allow tensioning on the wedge belt drive with the torque arm which should really preferably be in tension. if output hub runs anti-clockwise. torque arm ought to be positioned the correct.
3. lnstall torque-arm fulcrum on the rigid help to ensure the torque-arm will probably be at roughly appropriate angles to your center line 
with the driven shaft and also the torque arm case bolt. make sure there’s enough get up while in the turnbuckle for belt tension adjustment.
Keep close.
Bell drive may be located in any effortless postion. if your torque arm should be to be employed to tighten the belts, the drive need to be at about tight angle on the line concerning the input and output shafts.
Bell drive may be located to your proper if sought after.
If output hub rotates clock-wise. place belt drive and torque arm in opposite path to that shown during the illustration.
Torque arm and belt consider up.
Torque arm might be mounted to your correct if preferred.
