C Style Flex-Flex Couplings
The C Sort coupling includes two flex hubs, a single sleeve and one accessory kit consisting of seals and snap rings.
CFR Style Flex-Rigid Couplings
The CFR Style coupling consist of one particular flex hub, one particular rigid hub, one sleeve, one accessory kit consisting of 
seals and snap rings.
Capabilities
Simple and economical variety of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in place
Accessible as vertical and horizontal couplings
Wide variety of particular variations such as full-flex, flex-rigid mill motor
Normal configurations can be found from the shelf
Ordering Facts
Application: Driver and Driven.
Type and dimension of coupling, horizontal, vertical etc.
Electrical power: Motor horspower or torque requirement.
Speed: Motor RPM or Driven RPM.
Distance in between shaft ends (BSE).
Shaft sizes.
C and CFR Sort Couplings
Ordering Info
Puller Holes are common on sizes four through 12.
Puller Holes are available for sizes 7/8 by way of three.five at an additional charge.
The BSE (distance Among Shaft Ends) may vary amongst G and G1.
Interference bores without set screws are common unless otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, consult Engineering Section.
Larger sizes are available, please talk to Technical Help.
