Materials Handling Energy UNIT 2
General Description
This electrical power unit options electrical power up gravity down circuit. Activate the get started solenoid to start out the motor to lift the machine. The lowing motion is activated from the solenoid valve with all the lowering pace managed through the strain compensated movement management valve. Goods of this series might be extensively used in the marketplace of logistic products like fork lift, mini lift table, and so forth.
Exclusive Notes
1. The duty of this power unit is S3,i.e.,thirty seconds on and 270 senconds off.
two. Clean every one of the hydraulic components concerned in advance of mounting the energy unit.
3. Viscosity of your hydraulic oil shoud be 15~46 cst,which need to also be clean and no cost of impurities, N46 hydraulic oil is advisable .
four. Oil altering is needed just after the original 100 operation hours,afterwards when just about every 3000 hours.
5. The power unit needs to be mounted horizontally.
Materials Handling Energy UNIT 1
Common Description
This electrical power unit is intended for your fork lift market, consisting of really effective gear pump, DC motor, manual increase and reduce valve, tank, ect. The up and down movement are controlled by the lever from the manual release valve, that’s outfitted with an electrical switch to activate the motor. The lowing pace is managed through the pressure compensated flow manage valve.
Special Notes
one. The duty of this electrical power unit is S3, i.e. thirty seconds on and 270 senconds off.
2. Clean all the hydraulic components concerned just before installation of the power 
unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst, which should also be clean and totally free of impurities, N46 hydraulic oil is encouraged .
four. Oil altering is required immediately after the initial one hundred operation hours, afterwards after every 3000 hrs.
5. The power unit shown is created to be mounted horizontally.